High-pressure water removes temporary job site markings, airport markings, road and parking markings or rubber abrasion.
Road mark removal is possible with different methods.
When milling, a rotating milling cutter mechanically removes the markings.
Shot peening spins small abrasive grains at high speed on the surface destroys the lane marking.
Certain marking materials can be flame treated. The heat of the flame burns the material.
Dry-ice blasting undercools and embrittles the marking with the aid of dry ice particles and blasts them off the surface.
The road mark removal with high-pressure technology uses jet water to remove the markings from the substrates.
In order to achieve a good cleaning effect, the water is to be radiated to the surface at high pressure via special nozzles. Pressures of up to 2,800 bar are used. For large-scale removal work, the devices must be dimensioned so that they convey enough water and act on the surface in the appropriate width.
For the removal of roadmarks, lanes and runways, URACA offers a wide range of individual devices and complete solutions, consisting of high-pressure units and application-specific accessories.
The high pressure method is ideally suited for the demarcation of lanes and runways. It can be used for various substrates and marking materials. Despite a high cleaning effect, it does not damage the substrate. If you want to remove lane markings and are looking for a solution, URACA is the right partner for you. It provides you with suitable complete solutions including accessories. Contact URACA now. The URACA experts are happy to assist you with the selection of the products.